Ulbrich Precision Update - Page 46

An estimated 3.5 million manufacturing jobs will be needed in the United States within the next decade and 2 million of those positions are expected to go unfilled. The reason for the widening divide is threefold: the retiring baby-boomer generation, economic expansion, and a declining pool of ski... Continue Reading

Seimens USA: Power Factor Increases from 0.2 to 1.0 on Ulbrich’s 5Z Rolling MillAdvanced motors and drives replace old equipment, with estimated total cost of upgrade being recouped in less than two years of energy-savings alone, thanks to regenerative drive technology from Siemens.Most coil steel c... Continue Reading

Amid the recent Lean Transformation taking hold at Ulbrich, our Information Technology Department was featured in a recent Dell case study. The study identifies and details a new strategy to “lean out” and enhance IT’s methods for backing up data. In collaboration with Dell Software, Ulbrich’s IT De... Continue Reading

Each of our 12 divisions of stainless steel & special metal reroll mills and service centers in 5 countries specialize in producing metal strip, foil and wire products for critical end uses in the Energy and Power Generation Industries. Waspaloy® and L605 are used in Turbine Blades/Stator V... Continue Reading

When Good Forming Is Needed At Super-High Tensiles 301 has been long used for compression spring applications. Full Hard and Extra Full hard tempers being the most common ordering condition for traditional springs. For those customers whose applications require high ductility at extra hard tempers... Continue Reading