Grade 5 Titanium (Ti-6Al-4V) Wire UNS R56400

Grade 5 Titanium (Ti 6-4) is one of the most versatile titanium alloys. Typical applications include compressor blades, discs, rings for jet engines, aircraft components, pressure vessels, and rocket engine cases. Grade 5 titanium is much stronger than commercially pure titanium, with the same stiffness and most of the same thermal properties making it a great selection for demanding applications.
Download Datasheet

Full Name
Email
Company
Quantity (lbs/kg)

Grade 5 Titanium Shaped, Flat, Square, Round, Fine Wire, Plated and Un-plated ASTM B265, AMS 4911, AMS 4928


Grade 5 Titanium 6Al-4V Alloy Description

Stronger than commercially pure titanium alloys is titanium 6Al-4V (Grade 5). Among its many advantages the alloy is heat treatable, has an excellent combination of strength, corrosion resistance, weldability and formability.

Applications

  • Tension set rings
  • Bolts
  • bicycle part
  • Biomedical implant
  • High-temperature structural applications in the aircraft industry

Chemistry Typical


Titanium: Balance
Vanadium: 4.0
Aluminum: 6.0
Hydrogen: 0.015 max
Nitrogen: 0.02 max
Carbon: 0.10 max
Iron: 0.25 max
Residual each: 0.10 max., total 0.40 max

Physical Properties


Density, 0.16 lbs/in³, 4.43 g/cm³

Mean Coefficient of Thermal Expansion: in/in/°F (mm/m/°C):
70- 212°F (20- 100°C): 4.78 x 10 (8.6)

Thermal Conductivity: BTU-in/h-ft-°F (W/m-°K):
At 70°F (21°C): 46.5 (6.7)

Modulus of Elasticity: KSI (MPa)
16.5 x 10³ (113.8 x 10³) in tension

Melting Point: 3020°F (1660°C)

Mechanical Properties at Room Temperature


Properties: Annealed (Typical)


Ultimate Tensile Strength: 135 KSI (950 MPa)
Yield Strength (0.2% offset): 125 KSI (880 MPa)
Elongation: 15%
Hardness: Rc 34

Properties: Tempered


Contact Ulbrich Wire with requirements.


Additional Properties



Ti-6Al-4V Corrosion Resistance


Refer to NACE (National Association of Corrosion Engineers) for recommendations.

Finishes


Inquire with Ulbrich Wire

Forms

  • Continuous Coils
  • Cut to length
  • Precision cutting

Heat Treatment of Ti-6Al-4V


Titanium 6-4 (Grade 5) be hardened by cold working and heat treating.

Welding Grade 5 Titanium


For best results refer to: SSINA’s “Welding of Stainless Steels and Other Joining Methods”

Limitation of Liability and Disclaimer of Warranty: In no event will Ulbrich Stainless Steels and Special Metals, Inc., be liable for any damages arising from the use of the information included in this document or that it is suitable for the ‘applications’ noted. We believe the information and data provided to be accurate to the best of our knowledge but, all data is considered typical values only. It is intended for reference and general information and not recommended for specification, design or engineering purposes. Ulbrich assumes no implied or express warranty in regard to the creation or accuracy of the data provided in this document.

Contact Us

Full Name
Title
Company
City, State, Country
Email
Phone (Optional)
Message (Optional)