Ulbrich Precision Update - Page 46

Seimens USA: Power Factor Increases from 0.2 to 1.0 on Ulbrich’s 5Z Rolling MillAdvanced motors and drives replace old equipment, with estimated total cost of upgrade being recouped in less than two years of energy-savings alone, thanks to regenerative drive technology from Siemens.Most coil steel c... Continue Reading

Amid the recent Lean Transformation taking hold at Ulbrich, our Information Technology Department was featured in a recent Dell case study. The study identifies and details a new strategy to “lean out” and enhance IT’s methods for backing up data. In collaboration with Dell Software, Ulbrich’s IT De... Continue Reading

Each of our 12 divisions of stainless steel & special metal reroll mills and service centers in 5 countries specialize in producing metal strip, foil and wire products for critical end uses in the Energy and Power Generation Industries. Waspaloy® and L605 are used in Turbine Blades/Stator V... Continue Reading

When Good Forming Is Needed At Super-High Tensiles 301 has been long used for compression spring applications. Full Hard and Extra Full hard tempers being the most common ordering condition for traditional springs. For those customers whose applications require high ductility at extra hard tempers... Continue Reading

Ulbrich Stainless Steels & Special Metals, Inc., is pleased to offer downloadable PDFs of our alloy datasheets. These alloy datasheets were designed to provide metal product and design engineers chemical composition, as well as physical and material properties to the 100 plus alloys that Ulbrich off... Continue Reading