Flat, Shaped and Round Wire 


High strength wire, Masonry nails, Springs, Cutting tools, Knives 


High carbon steels are difficult to weld because they contain carbon in the range of 0.6 percent to 1.0 percent. High carbon steels are susceptible to heat, and it easily flame hardened which allows it to be worked into many different forms. High carbon steels have greater tensile strength and are used to create products where strength is required. 

Chemistry Typical 

Uns#         Carbon        Magnanese      Phosphorous       Sulfur            Iron

G10600        0.55-0.65       0.60-0.90            0.040 max              0.050 max         balance
G10650        0.60-0.70       0.60-0.90            0.040 max              0.050 max         balance
G10700        0.65-0.75       0.60-0.90            0.040 max              0.050 max         balance
G10750        0.70-0.80       0.40-0.70            0.040 max              0.050 max         balance
G10800        0.75-0.88       0.60-0.90            0.040 max              0.050 max         balance
G10850        0.80-0.93       0.70-1.00            0.040 max              0.050 max         balance
G10900        0.85-0.98       0.60-0.70            0.040 max              0.050 max         balance
G10950        0.91-1.03       0.30-0.50            0.040 max              0.050 max         balance

 * Contact Ulbrich Wire for request regarding the availability of other aluminum alloys.

Physical Properties 

Typical Density: 0.278 - 0.290 lbs/in3, 7.85 - 8.03 g/cm3

Electrical Resistivity (typical): (ohm-cm@ 32° F, cold drawn): 0.0000163 - 0.0000180 

Thermal Conductivity (typical): BTU-in/hr-ft2-°F: 346 

Mean Coefficient of Thermal Expansion (typical): µin/in-°F: 
68 - 212 °F: 6.11 - 6.67 

Modulus of Elasticity: KSI 
29.7 x 103 in tension 

Melting Temperature: 2600 - 2800 °F (1425 - 1540 °C) 


Profile, Round, Flat, Square 

Mechanical Properties at Room Temperature 

Properties: Cold Drawn (Typical)

Ultimate Tensile Strength: 92 KSI min (635 MPa min)
Yield Strength: 70 KSI min (485 MPa min)
Elongation: 10% min 

Properties: Tempered

These alloys can be cold worked to various tempers. 

* Actual physical and mechanical properties are alloy dependent. Contact Ulbrich Technical Service for alloy specific properties.

Additional Properties

Wire Finishes

XC - Extra clean. Annealed or annealed and cold rolled. 

* Contact Ulbrich Wire with special finish requests.

Heat Treatment

These alloys are hardenable by cold working and heat treating. 

*Contact Ulbrich Wire for additional information.


Contact Ulbrich Wire for specific information. 

Limitation of Liability and Disclaimer of Warranty: In no event will Ulbrich Stainless Steels & Special Metals, Inc., be liable for any damages arising from the use of the information included in this document or that it is suitable for the 'applications' noted. We believe the information and data provided to be accurate to the best of our knowledge but, all data is considered typical values only. It is intended for reference and general information and not recommended for specification, design or engineering purposes. Ulbrich assumes no implied or express warranty in regard to the creation or accuracy of the data provided in this document.


Contact Us

Full Name
City, State, Country
Phone (Optional)
Message (Optional)