Alloy 52 Wire UNS N14052

Alloy 52 was developed for glass-to-metal seals for some of the soft glasses and ceramics.

Full Name
Email
Company
Business Address

Shaped, Flat, Square, Round, Fine Wire, Plated and Bare Wire ASTM F30

Alloy 52 Description


Alloy 52 was developed for glass-to-metal seals for some of the soft glasses and ceramics. The alloy’s rate of thermal expansion is virtually constant to a temperature of about 1050°F (565°C).

Applications


Magnetic reed switches
Glass to metal seals that need controlled linear expansion

Chemistry Typical


Carbon: 0.05 max
Silicon: 0.30 max
Manganese: 0.60 max
Nickel: 50.5 nom
Chromium: 0.25 max
Iron: Balance
Phosphorus: 0.025 max
Sulfur: 0.025 max
Aluminum: 0.10 max

Physical Properties


Density: 0.30 lb/in³, 8.30 g/cm³

Electrical Resistivity: ohm-cir-mil/ft, microhm-cm:
At 68°F (20°C): 258(43)

Thermal Conductivity: BTU-in/hr-ft²-°F (W/m•K):
68-212°F (20-100°C): 97(140)

Mean Coefficient of Thermal Expansion: µin/in-°F (µm/m-°C):
77-842°F (25-450°C): 5.4 (9.8)

Melting Point: 2600°F (1430°C)

Mechanical Properties at Room Temperature


Properties: Annealed Typical

Ultimate Tensile Strength: 78 KSI nom (536 MPa nom)
Yield Strength: 35 KSI nom (240 MPa nom) Elongation: 30% nom
Hardness: Rb 73 nom

Properties Tempered


Alloy 52 can be cold rolled to achieve the temper properties required by specific customers and/or manufacturing requirements. Contact Ulbrich Wire for details.

Additional Properties

Corrosion Resistance


Refer to NACE (National Association of Corrosion Engineers) for recommendations.

Standard Wire Finishes


Extra Clean: (XC) Extra clean is also referred to as “bright annealed” or “bright annealed and cold rolled”
Grease (round wire only): Drawn in a heavy grease produces an “Ultra bright” finish for decorative applications
Soap (round wire only): Soap is used as a lubricant in the drawing process and is not removed. It acts as a lubricant during customer part forming operation. A soap finish is available in tempered products.
Plated: Many plating options are available.
∗Special finishes are available: Contact Ulbrich Wire Sales with special finish and plating requests.

Forms

Continuous Coils
Cut to lengths
Precision cutting

Heat Treatment

Alloy 52 is non hardenable by heat treatment.

Welding

For best results refer to: SSINA’s “Welding of Stainless Steels and Other Joining Methods”.


Limitation of Liability and Disclaimer of Warranty: In no event will Ulbrich Stainless Steels and Special Metals, Inc., be liable for any damages arising from the use of the information included in this document or that it is suitable for the ‘applications’ noted. We believe the information and data provided to be accurate to the best of our knowledge but, all data is considered typical values only. It is intended for reference and general information and not recommended for specification, design or engineering purposes. Ulbrich assumes no implied or express warranty in regard to the creation or accuracy of the data provided in this document.

success Your information has been submitted successfully and an Ulbrich specialist will be in touch with you soon.

Contact Us

Full Name
  • ${ error }
Email
  • ${ error }
Company
  • ${ error }
Title
Business Address
  • ${ error }
Phone
Message