Shaped, Flat, Square, Round, Fine Wire, Plated and Un-plated ASTM B265 GR3, AMS 4900K, ASTM F67, MIL-T-9046CP2


Commercially Pure Titanium Grade 3 Wire Description Description


Commercially pure Titanium Grade 3 has higher mechanical properties than Grade 2 while displaying similar ductility and formability. It can be used for parts requiring strength up to 400°F and oxidation resistance to 600°F.

Applications


Metal gaskets
Marine applications
Medical devices
Heat exchanger components
Deep drawing applications

Chemistry Typical


Titanium: Balance
Iron: 0.30 max
Oxygen: 0.35 max
Carbon: 0.80 max
Nitrogen: 0.05 max
Hydrogen: 0.015 max
Residuals each 0.10 max, total 0.40 max

Physical Properties


Density, 0.163 lbs/in³,(4.51 g/cm³)

Mean Coefficient of Thermal Expansion, in/in/°F (mm/m/°C)
70- 212°F (20- 100°C) 4.78 x 10 (8.6)

Thermal Conductivity: BTU-in/h-ft-°F (W/m-°K)
At 70°F (21°C): 138 (19.9)

Modulus of Elasticity, KSI (MPa)
15.2 x 10³ (105 x 10³) in tension

Melting Point: 3020°F (1660°C)

Mechanical Properties at Room Temperature


Annealed


Ultimate Tensile Strength: 65 KSI min (448 MPa min)
Yield Strength: (0.2 Offset) 55-80 KSI (379-552 MPa)
Elongation: 18% min

Properties Tempered


Commercially Pure Titanium Grade 3 can be cold rolled to achieve the temper properties required by specific customers and/or manufacturing requirements. 

Contact Ulbrich Wire for details.

Additional Properties


Corrosion Resistance

Refer to NACE (National Association of Corrosion Engineers)for recommendations.

Standard Wire Finishes


Extra Clean: (XC) Extra clean is also referred to as “bright annealed” or “bright annealed and cold rolled”

Grease (round wire only): Drawn in a heavy grease produces an “Ultra bright” finish for decorative applications

Soap (round wire only): Soap is used as a lubricant in the drawing process and is not removed. It acts as a lubricant during customer part forming operation. 

A soap finish is available in tempered products.
Plated: Many plating options are available.
*Special finishes are available: Contact Ulbrich Wire Sales with special finish and plating requests.

Forms


Continuous Coils
Cut to lengths
Precision cutting

Heat Treatment


Commercially Pure Titanium Grade 3 can only be hardened by cold work

Welding


For best results refer to: SSINA’s “Welding of Stainless Steels and Other Joining Methods”

Limitation of Liability and Disclaimer of Warranty: In no event will Ulbrich Stainless Steels and Special Metals, Inc., be liable for any damages arising from the use of the information included in this document or that it is suitable for the ‘applications’ noted. We believe the information and data provided to be accurate to the best of our knowledge but, all data is considered typical values only. It is intended for reference and general information and not recommended for specification, design or engineering purposes. Ulbrich assumes no implied or express warranty in regard to the creation or accuracy of the data provided in this document.

Contact Us

Full Name
Title
Company
City, State, Country
Email
Phone (Optional)
Message (Optional)