|
|
- Home
- Products & Capabilities
- Grades & Alloys
- Industries Served
- Quality
- News
- Locations
- Corporate History
- Contact Us
|
|
|
Ulbrich : Products & Capabilities : Strip Coil : Rolling & Annealing
 |
 |
We accept any challenge for difficult to produce dimensions, tolerances, and specifications.
| US Units | Metric Units | |
| Thickness (min - max) | <0.0005 - 0.125 in. | .0007 - .187 mm |
| Typical Tolerance | + 5% | + 5% |
| Extreme Tolerance | + 1% | + 1% |
| Width MAX | 14 | 356 |
| Coil Weight | 5-6000 #/in cu. 60" OD Max | 0.09-2700 kg/mm.width 1524 mm OD max |
| Annealing Temperature (min - max) | 1200 - 2200° F | 650 - 1200° C |
| Atmosphere | Various - to specification | Various - to specification |
Austenitic grades - dead soft to extra hard, bright finish In the annealed state, all austenitic alloys are non-magnetic; however, work hardening makes most types slightly magnetic. These steels cannot be hardened by heat treatment, but can be worked to develop high tensile strengths.
Ferritic grades - dead soft to full hard
FinishesCustomers can specify numerous unique finishes ranging from dull gray matte, to bright and highly reflective.
Custom Materials
Hot or cold rolled bands; vacuum melt, induction melt, special or restricted analysis upon request.
In addition to the listed alloys, we produce several electronic, glass sealing, and low expansion alloys, as well
as these special grades.
* Measurements for general information only. Ultimate capabilities may differ depending on order requirements.